Pallet Rack Parts: How to Identify the Right Component
- 13/11/2026
- Posted by: tendou
- Category: Racking System
When a pallet rack needs a replacement part or a change, start with the manufacturer’s drawing or the original order. Use the names below to describe what you need. Ask the supplier to confirm the exact part and its compatibility with the installed rack.
Frame, uprights and bracing
The uprights are the vertical posts. Bracing connects the uprights within each frame, and base plates sit where the uprights meet the floor. A row spacer connects frames in a back-to-back arrangement. It is a separate part from the bracing within a frame.
What to send: the frame or upright reference, rack series and drawing revision. If you only have a bay number or load notice, give the supplier that reference and explain what is missing from your records.
Beams, connectors and locking pins
Beams span between frames and support the pallets or specified decking. The end connector joins the beam to the upright. A locking pin or clip on systems that use one helps prevent the beam from being lifted out of its connection. Its shape and fit depend on the rack system.
What to send: the beam and connector references and the drawing for that level. Ask the supplier to identify the correct locking device and check the documented capacity for the proposed configuration. Similar-looking connectors or pins do not prove compatibility. For one manufacturer’s example, see Dexion’s locking pin.
Decking and pallet support bars
Decking provides a surface across the beams. A pallet support bar is a separate component used where the design calls for additional pallet support. The drawing should show which component is specified and where it sits.
What to send: the existing deck or support reference, the layout drawing and details of the loaded pallet or goods. Ask whether the proposed part suits the beam arrangement and load. If you need to check what the existing rack is rated for, see how to read a rack load label.
Upright protectors and barriers
Upright protectors and barriers help shield exposed parts of the rack from handling equipment. The correct choice depends on which part is exposed and the clearance available in the actual layout.
What to send: identify whether you mean a protector for an upright or a barrier at the end of a row. Ask the supplier to check the fit and the clearance for the handling equipment in use.
Hyperack’s customer booklet illustrates these parts on printed page 17. The illustration helps identify names. Use the documents for your own rack to confirm which parts apply. For another manufacturer’s component reference, see Stow’s conventional pallet racking.
Copyable parts enquiry checklist
- Rack manufacturer and series, if known
- Row, bay and level identifiers
- Drawing number and revision, original order or load-label reference
- Part name and part number, if available
- Quantity and reason for the request, such as a replacement or an extra level
- Existing photographs, or photographs that can be taken safely from outside any restricted area
If the rack is damaged, follow your site’s isolation procedure and arrange an assessment. Avoid approaching or handling the damaged bay to identify the part. See what a racking inspection covers or what to confirm before altering the rack.
For a new layout, see Hyperack’s selective pallet racking system. To discuss an existing rack, contact Hyperack with the checklist above and ask what can be confirmed from your records.


